Windows Defender: how to turn ON PUA protection (Powershell)

[Lano]

Hi guys, WD is improved very much in newer releases. But how can we enable PUA? Simply open Powershell and type this:

Set-MpPreference -PUAProtection 1
To disable it just type:
Set-MpPreference -PUAProtection 0

I have some questions.

1. - Previously Powershell was needed run in elevated mode, has it changed now?
   
2. - Previously, was  also possible to use the so-called "audit mode", is this mode no longer available?
   

---

1. Open an elevated PowerShell.
2. Enter the command below you want to use into the elevated PowerShell, and press Enter.

(Disable Windows Defender PUA protection - Default settings)
 Set-MpPreference -PUAProtection 0
or
 Set-MpPreference -PUAProtection Disabled

OR

(Enable Windows Defender PUA protection)
 Set-MpPreference -PUAProtection 1
or
 Set-MpPreference -PUAProtection Enabled

OR

(Audit Mode - will detect PUAs, but will not block them)
 Set-MpPreference -PUAProtection 2
or
 Set-MpPreference -PUAProtection AuditMode